Corona Discharge (CD) Ozone (O₃) Generator with Nicola Tesla Technology
for
Water Ozonation & Oxygenation

Ozonate water to raise its oxygen content by bubbling ozone through it.

PLEASE NOTE: The WOZ4 is being replaced by the manufacturer with a new model and is NO LONGER AVAILABLE. The new model will not be shipping until sometime early in 2007.

We have 2 other excellent water ozonators, the Nature-Kleen and the Ozonator 400. The Nature-Kleen ozonator is a very well-made high-output water ozonator with quiet, smooth operation and a 60-minute auto-timer shut-off. Click here for more details.

The Ozonator 400 is a low-cost excellent ozonator that is also quiet and smooth with a 30-minute auto-timer shut-off, plus it comes with two sets of bubble stones and tubing! Click here for more details.

Click here for info on other ozone products.

"First Aid Kit of the Future"

Full instructions about the use and benefits of the Water Ozonator can be found in the research papers published by Dr. Robert (Bob) C. Beck. The Water Ozonator is an adjunct to the research that is based on the original paper by Dr. Beck entitled "Experimental IN VIVO Blood Virus, Microbe, Fungi, and Parasite Elimination Device for Experimental/Theoretical HIV Blood Neutralization".  To read an on-line version of the original Patent # 5,188,738 click here.

With over 200mg/Hr output and a new custom Air-Pump, the WOZ4 will be one of the best ozonators yet!

The WOZ4 outputs nearly twice the ozone (200mg/Hr) as the previous WOZ3 (108mg/Hr) thanks to a super-efficient new ozone tube design.  It also has a newly designed Air-Pump that is totally ozone resistant and runs with far less vibration.

Disclaimer

This unit is for researchers only. The unit and literature have not been evaluated by the Food and Drug Administration in the U.S. or the Health Protection Branch in Canada. This product is not intended to cure or treat any disease. Government health departments and medical associations state that you must consult a medical doctor for treatment of all diseases. Individual results may vary.

NOTE:  Our Water Ozonators include an International Wall Adapter intended for any voltage from 110VAC 60 Hz (North America) to 220/240 Volt AC 50 Hz Mains (as found in International Countries). With it you can use our WOZ virtually anywhere in the world.

What is the "Water O₃zonator"?

The Water O₃zonator Model# WOZ4 is a  true* 200mg/Hr Corona Discharge (CD) Ozone (O₃) Generator used for Water Ozonation & Oxygenation that is powered by 12 Volts DC. Ozone has powerful oxidation potential and is used to disinfect, sterilize and oxygenate water. (Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.)

NOTE: The Ozone generated by the Water O₃zonator is NOT intended to be breathed in! It is intended for water ozonation only. Ozone can be very damaging (through rapid and powerful oxidation) to sensitive lung tissues. Always use the Water O₃zonator in a well ventilated area. A stove-top exhaust fan works well to remove the off gas of the Water O₃zonator unit.

NOTE:The WOZ4 unit's output ozone concentration is below permissible levels (<0.05 PPM) at a distance greater than 48" from unit.

NOTE: Exposure levels of Ozone in air at 0.1 ppm can be tolerated for up to 8 hours before being considered a hazard. With the WOZ4, the Ozone reading in the air is 0.1 ppm and less, 24” from the source. At 48” from the source, the reading is 0.06 ppm and less.

NOTE: The WOZ4 unit is not a medical grade ozone generator. Medical grade ozonators usually cost 5-10 times more than even excellent quality, non-medical ozonators like the WOZ4. Because our model WOZ4 ozonator does not incorporate medical grade components, it is recommended that you do not attempt to feed pure oxygen (O₂) into the chamber. This caution applies to any ozone generator on the market that does not have medical grade parts and components throughout. 

The WOZ4 outputs a true 200mg/Hr. (Measured with a GM Anceros ozone-in-air analyzer).

Ozone concentration is a maximum of 2.9 Gamma (ug/ml or mg/l) at 0.5 LPM flowrate. The WOZ4 can ozonate an 8 ounce (250mL) glass of room temperature water in less than 1 minute and achieve an ORP (Oxidation-Reduction Potential) of over an outstanding +1,000mV ORP in less than 3 minutes). Water sterilization occurs at greater than 600mV ORP, thus the WOZ4 exceeds the requirements for water sterilization.

Click the image to the left for an enlarged picture of an independent FDA recognized laboratory analysis of our previous 108mg/Hr WOZ3 unit against E.Coli (Escherichia coli ATCC 8739 [ESC]), Staph. (Staphylococcus aureus ATCC 6538 [SAU]), and Pseudomonas (Pseudomonas aeruginosa ATCC 9027 [PAS])

Using advanced principles of the 1900's inventor-genius Nicola Tesla, our manufacturer has designed an exclusive, state-of-the-art ozone (O₃) generation unit that incorporates a new and proprietary approach to ozone generation: Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS). This results in the WOZ4 requiring less than 1.2 Amps current at 12 Volts DC to operate both the Ozone Generator and the built-in Air Pump, allowing for quiet and reliable operation.

The Water O₃zonator uses state-of-the-art electronics and a unique circuit design allowing the unit to be extremely lightweight, portable, powerful, efficient and able to run off a 12 Volt DC power source like an automobile battery if needed. The Water O₃zonator unit takes less than 2 minutes to achieve maximum Oxidation Reduction Potential (ORP in mV) in an 8 ounce glass (250 ml) of chilled and purified water to +1,000mV ORP. For 32 ounces (1 Litre), expect full ORP in less than 10 minutes (see graph below).

For a technical explanation of Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS) click the links.

Click the image above to see the
internal components of the WOZ4.

Unique Features

• O₃ rating: True* 200mg/Hr @ 2.0 LPM output (*Measured with a GM Anceros ozone-in-air analyzer. Many manufacturers measure ozone output with the chemical titration method, which gives an incorrectly high reading. Our WOZ3 would be rated at over 200mg/Hr with this test method.)
  
• O₃ concentration: 2.9 Gamma (ug/ml or mg/l) @ 0.5 LPM
  
• Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.
  
• Ozone Tube uses high-grade type 214 Fused Quartz Crystal (99.995% pure quartz crystal)
  
• High Frequency Corona Discharge (CD) design for quiet, efficient operation
  
• Built-in Air Pump rated 0.5PSI @ 2.0 LPM
  
• Super-lightweight and portable design: Weighs only 3 Lbs (1.3 kgs)
  
• Simple operation. Turn the unit on and it's ready to operate.
  
• 12 Volts DC @ 1.2 Amps. (Comes with an AC-DC Wall Adapter rated at 12 Volts DC @ 1.5 Amps)
  
• Utilizes SOTA's proprietary (inventor-genius Nicola Tesla based) Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS) for extremely efficient and reliable operation
  
• Aluminum-free. Absolutely NO aluminum or ceramic alumina (aluminum oxide) used in the ozone path.
  
• Ceramic Air Stone: featuring a 90 micron pore diameter, extremely durable, long lasting, inert and non-toxic, high performance air bubbles. Inlet pipette is made of Kynar, a highly ozone resistant material used in medical grade ozonators.

• Silicone Air Tubing: will never harden, crack or kink.
  
• Maximum ORP (mV) Saturation: <5 minutes per 8 ounces (250 ml) chilled  and purified water
  
• +1,000mV ORP <20 minutes for 32 ounces (1 Litre).

The Complete Water Ozonator Unit

Click on image to enlarge it

Electronics

Our Corona Discharge (CD) Ozone Generator uses proprietary state-of-the-art electronics allowing for great efficiency, super-lightweight design, and powerful output.

Specifications

• Ozone (O₃) Output: True* 200mg/Hr Ozone (O₃) production at 2.0 LPM
• O₃ Concentration: 2.9 Gamma (ug/ml or mg/l) at 0.5 LPM
• Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.
• Powered by 12 Volts DC @ 1.2 Amp.
• Air Pump: Built-in to WOZ3 unit outputs 0.5 PSI @ 2,000 cc (2 LPM)
• Maximum ORP (mV) Saturation: <5 minutes per 8 ounces (250 ml) chilled and purified reaches over +1,000mV ORP <20 minutes for 32 ounces (1 Litre).

Dimensions

• Water O₃zonator:  7.9" Wide x 6.25" Deep x 2.5" High (20cm Wide x 16cm Deep x 6.5cm High). Casing is high-impact ABS plastic. PC-Bone Colour. Weight 3 Lbs (1.3 kgs).

Each Water Ozonator comes complete with:

• The Water O₃zonator WOZ4 unit (200mg/Hr Corona Discharge (CD) Ozone Generator w/ Built-in Air Pump)
• Operating Instructions
• Ceramic Air Stone
• 4 Feet total of Silicone Air Tubing
• Our WOZ ships with an International Wall Adapter intended for any voltage from110VAC 60 Hz (North America) to 220/240 Volt AC 50 Hz Mains (as found in International Countries). With it you can use your new WOZ3 virtually anywhere in the world. The AC-DC Wall Adaptor is rated at 12 Volts DC @ 1.5 Amps, centre positive. (NOTE: This wall adapter can be used on The Silver Pulser, The Silver Maker, or The Magnetic Pulser .)

• Our WOZ4 ships with an International Wall Adapter intended for any voltage from110VAC 60 Hz (North America) to 220/240 Volt AC 50 Hz Mains (as found in International Countries). With it you can use your new WOZ4 virtually anywhere in the world.

• Additionally, the Water Ozonator may also be operated directly from a 12 Volt DC Battery like an automobile cigarette lighter. You will need to purchase an adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like from Radio Shack®.

Options for Powering the Water O₃zonator

In the event of a power outage here are some options for powering the Water Ozonator:

1. The WOZ4 Water Ozonator may be operated directly from a 12 Volt DC Battery like an automobile cigarette lighter. You will need to purchase an adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like from Radio Shack®.
   

2. The WOZ4 Water Ozonator Unit can be powered by a suitable solar panel. Keep in mind that most solar panel generators are used to re-charge a battery which in turn operates the unit. Therefore we suggest you use a solar panel (preferably a sealed Gel-Cel® type) to re-charge a 12 Volt DC automobile battery, then run the WOZ3 Water O₃zonator Unit directly from the battery. You will need to use a cord which has alligator clips on one end to attach to the battery terminals, and the appropriate Centre Positive, 2.1mm Plug on the other end to plug into the WOZ3 Water Ozonator Unit. Be careful with polarity! This type of cord with alligator clips on one end is probably not readily available, therefore you will to need to buy a cord and cut off the end that normally goes into the cigarette lighter, and solder your own set of alligator clips. Use a black and red alligator clips so you ensure polarity is correct each time you connect the circuit.
   

3. If you wish to operate the WOZ4 Water Ozonator Unit directly from a solar panel you will need to use a 12 Volt DC output panel that is capable of supplying at least 2 Amps. The WOZ4 Water Ozonator Unit's initial starting demands may require a higher output solar panel. That is why it is preferable to use a charged 12 Volt DC battery instead.

What about a Warranty?

The Water O₃zonator is covered by a full 2 Year Parts and Labor Warranty.